Electrical Engineering Questions
Explore questions in the Electrical Engineering category that you can ask Spark.E!
transferred electron device is a form of a diode a two terminal semiconductor electronic component with negative resistance used in high frequency electron
Infinite open-loop gain G= vout/v..... Infinte input impedance Rin, and so zero input current. Zero input offset voltage. Infinite output voltage range. Infinite bandwidth with zero phase shift and infinite slew rate. Zero output impedence R.
a type of analog linear filter with a maximally flat group/phase delay.
an electronic feedback loop consisting of a phase vector a low pass filter and voltage controlled oscillator
The voltage of batteries in parallel causes the length of use to _______________
Ohm's law explains the relationship between _______________, _______________, and _______________
Power is measured in _______________
_______________ is the same in a parallel circuit
A series circuit _______________ energy between resistors
A parallel circuit does not _______________ energy between resistors
_______________ is the same in a series circuit
The voltage of batteries in series add when it goes from (_______________ to _______________)
For an electric current, you need a _______________ _______________, a _______________ _______________, and a _______________
Commonly used for dedicated circuits (usually equipment and appliances requiring heavier power capacity), typically providing the capability to provide 120/240V power to a load.
Most commonly used in homes, has 1 power wire (hot), 1 neutral wire, and typically a ground wire and usually provides 120V to load. Power flows between the hot and neutral wire through a load.
An electric current which reverses direction periodically (and regularly)
Commonly used in heavier commercial applications where load capacity is greater as it provides ability to maintain a substantial amount of power at a relatively high efficiency rate due to overlapping frequency of output.
During normal operations at 100% power, the following sequence of events occurs: 1. The "COND DEMIN DP HI" annunciator comes in on Main Board 6. 2. The BOP reports that Polisher System Differential Pressure (3CND-PDI 20B) reads 65 psid and is stable. What is the required corrective action for this alarm condition?
With the plant initially at 100% power, a load reject occurs. Which valve is specifically designed to aid the Main Condenser in handling the increased energy input during this load reject; and what signal caused this valve to automatically open?
For a Turbine Load rejection event, what percentage of plant power is the Main Condenser designed to handle AND which component is specifically designed to aid in handling the load rejection?